Nady GTH-100 Manual - Page 6

REAR CONTROLS AND CONNECTIONS (1) (2) (3) (4) (5) (6) (7) 1. POWER CONNECTION A standard IEC AC power socket for connecting to the main AC supply. The IEC power socket has an integral fuse holder that takes a 20mm fuse. NOTE: • Always replace a blown fuse with the same type as specified on the rear panel and under Specifications (pg. 7) for the corresponding AC voltage being used. • Before you connect your GTH-100 to the AC, please make sure that your local voltage matches the Voltage Selector Switch. • Do not remove the center ground conductor. 2. VOLTAGE SELECTOR SWITCH For selecting the proper voltage (115/230VAC) to match the power supply in your area. 3. HIGH VOLTAGE FUSE 1A 250V fast blow fuse 4. FOOTSWITCH JACK For connecting to the included FS-2 dual footswitch. On the FS-2, the right switch controls the Reverb on/off. The left switch controls the Lead Boost on/off for adding up to 12dB of gain at the preamp stage. Note: connecting the FS-2 will automatically decrease the level at the preamp input stage allowing it to be boosted to a higher level when the Lead Boost is switched on. 5. SPEAKER OUTPUTS Power output jacks for connecting to 4Ω, 8Ω, and 16Ω speaker cabinets. Although compatible with many cabinets, for best results it is recommended that the GTH-100 be used to power the matching GAC-412 cabinet (8Ω), which utilizes (4x) 12" Nady PowerDrive™ speakers for optimum tone and maximum output. 6. LINE OUT This line level output signal is derived from the output of the power amp to incorporate all the characteristics, color and tonal response of the output tubes. This signal can be input into any device, such as an audio mixer or another amplifier, and can be useful in many live sound or recording applications. 7. REVERB OUT A pure reverb signal output. This may be used for recording by plugging into mixing consoles/recording devices or for stereo effects by using an outboard amp and speaker. 6