Netgear FS728TP FS728TP Hardware manual - Page 17
Step 3: Checking the Installation
 |
UPC - 606449050226
View all Netgear FS728TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
FS728TP Hardware Installation Guide 5. Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack. Figure 2-1 Step 3: Checking the Installation Note: Always install devices from the bottom of the to the top. This will prevent the rack from over balancing and toppling over. Before applying power perform the following: • Inspect the equipment thoroughly. • Verify that all cables are installed correctly. • Check cable routing to make sure cables are not damaged or creating a safety hazard. • Ensure all equipment is mounted properly and securely. 2-31 v1.0, November 2007 Installation
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12 -
13 -
14 -
15 -
16 -
17 -
18 -
19 -
20 -
21 -
22 -
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
 |
 |
FS728TP Hardware Installation Guide
2-31
Installation
v1.0, November 2007
5.
Tighten the screws with a #2 Phillips screwdriver to secure the switch in the rack.
Step 3: Checking the Installation
Before applying power perform the following:
•
Inspect the equipment thoroughly.
•
Verify that all cables are installed correctly.
•
Check cable routing to make sure cables are not damaged or creating a safety hazard.
•
Ensure all equipment is mounted properly and securely.
Figure 2-1
Note:
Always install devices from the bottom of the to the top. This will prevent the rack
from over balancing and toppling over.