Netgear GSM7324 FSM7326P Command line reference manual - Page 215
Class-Map Config
UPC - 606449029062
View all Netgear GSM7324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver- 13.3.11 match ip precedence This command adds to the specified class definition a match condition based on the value of the IP Precedence field in a packet, which is defined as the high-order three bits of the Service Type octet in the IP header (the low-order five bits are not checked). The precedence value is an integer from 0 to 7. Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a match criterion for the same Service Type field in the IP header, but with a slightly different user notation. Format Mode match ip precedence Class-Map Config 13.3.12 match ip tos This command adds to the specified class definition a match condition based on the value of the IP TOS field in a packet, which is defined as all eight bits of the Service Type octet in the IP header. The value of is a two-digit hexadecimal number from 00 to ff. The value of is a two-digit hexadecimal number from 00 to ff. The denotes the bit positions in that are used for comparison against the IP TOS field in a packet. For example, to check for an IP TOS value having bits 7 and 5 set and bit 1 clear, where bit 7 is most significant, use a value of a0 (hex) and a of a2 (hex). Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a match criterion for the same Service Type field in the IP header, but with a slightly different user notation. Note: This "free form" version of the IP DSCP/Precedence/TOS match specification gives the user complete control when specifying which bits of the IP Service Type field are checked. Format Mode match ip tos Class-Map Config Quality of Service (QoS) Commands v1.0, February 2007 13-15