Netgear GSM7328Sv1 Password recovery procedure for Layer 2 and Layer 3 switche
Netgear GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Manual
 |
View all Netgear GSM7328Sv1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Netgear GSM7328Sv1 manual content summary:
- Netgear GSM7328Sv1 | Password recovery procedure for Layer 2 and Layer 3 switche - Page 1
Password recovery procedure for Layer 2 and Layer 3 switches This document describes the procedure to reset to default the admin and enable passwords on Layer 2 and Layer 3 switches. The Password recovery feature is available from Firmware Version 7.3.1.7 Table of Contents Accessing the switch via - Netgear GSM7328Sv1 | Password recovery procedure for Layer 2 and Layer 3 switche - Page 2
Accessing the switch via the Console port ❶ ❶ Start Hyper Terminal and create a new connection (i.e. Switch) and click OK. NOTE: At this time the switch is turned off ➋ ➌ ➋ Choose the serial portal that will be used to connect the Console cable to the Switch Connect the Console cable (enclosed - Netgear GSM7328Sv1 | Password recovery procedure for Layer 2 and Layer 3 switche - Page 3
➍ Password recovery ➎ ➏ ➍ Power on the Switch (the output shown in the picture should be now visible in Hyper Terminal) The following two items will be displayed: 1 - Start FSM73xxS Application (depending on the switch model) 2 - Display Utility Menu ➎ Select 2 and press enter within 3 seconds from - Netgear GSM7328Sv1 | Password recovery procedure for Layer 2 and Layer 3 switche - Page 4
❼ The admin and enable passwords will now be reset to factory defaults as confirmed by output ❼ Once the procedure is completed the prompt will return to the Privileged EXEC mode (#) The admin and enable password are now both reset to default (no password) Setting the Admin and Enable passwords - Netgear GSM7328Sv1 | Password recovery procedure for Layer 2 and Layer 3 switche - Page 5
ENABLE PASSWORD Exit the Config mode with the Exit command Use CTRL+Z keys to exit the Privileged EXEC mode (#) Type the enable password command to enter the password mode Enter the old password (in this case press enter as there is no old password) Enter and Confirm the new password Save the - Netgear GSM7328Sv1 | Password recovery procedure for Layer 2 and Layer 3 switche - Page 6
RELOAD THE SWITCH Type the reload command to power cycle switch Enter Y when prompted The changes will take place once the reboot is completed and the user will be required to use the new admin password to login, and the enable password to access the Privileged EXEC mode Version 1.0
-
1 -
2 -
3 -
4 -
5 -
6
 |
 |
Version 1.0
Password recovery procedure for Layer 2 and Layer 3 switches
This document describes the procedure to reset to default the
admin
and
enable
passwords on
Layer 2 and Layer 3 switches.
The Password recovery feature is available from Firmware Version 7.3.1.7
Table of Contents
Accessing the switch via the Console port
...................................................................
2
Password recovery
...........................................................................................................
3
Setting the Admin and Enable passwords
...................................................................
4
Save the configuration and reload
.................................................................................
5