Netgear WG311v2 WG311v2 User Manual - Page 19
WG311 v2 Default Wireless Configuration Settings - windows 8
View all Netgear WG311v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installation Guide for the NETGEAR 54 Mbps Wireless PCI Adapter WG311 v2 WG311 v2 Default Wireless Configuration Settings If this is a new wireless network installation, use the factory default settings to set up the network and verify wireless connectivity. If this is an addition to an existing wireless network, you will need to identify the wireless configuration and security parameters already defined. Your NETGEAR 54 Mbps Wireless PCI Adapter WG311 v2 factory default basic settings are: • Network Name Service Set Identification (SSID): ANY - a special name which indicates the first available network will be used Note: In order for the WG311 v2 Wireless PCI Adapter to communicate with a wireless access point or wireless adapter, all devices must be configured with the same wireless network name (SSID). • Network Mode (Infrastructure or Ad-Hoc): Infrastructure • Data security WEP encryption: Disabled The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless PCI Adapter WG311 v2 for basic wireless connectivity to an access point. The procedures provide step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the version of Windows you are using. Basic Setup 2-3