Netgear WNDRMAC WNDRMAC Install Guide - Page 1
Netgear WNDRMAC Manual
View all Netgear WNDRMAC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Guide N600 Wireless Dual Band Gigabit Router WNDRMAC Package Contents: Ethernet Cable N600 Wireless Router Power Adapter Slide-on Router Stand Attach the STAND to the ROUTER: 1. Place the stand on a level surface. 2. Slide the router onto the stand. Step 1: Unplug the power to turn off your MODEM. Internet Step 2: Connect one end of the yellow ethernet cable ( ) to your MODEM, and the other end to the Internet port. N600 Wireless Router Step 3: Plug in, then turn on your MODEM. Wait approximately 2 minutes until your modem turns on. If your modem has a battery backup, first remove and reinsert the battery before connecting your modem to power. DSL or Cable Modem Step 4: Connect the power adapter to the ROUTER, then plug it into an outlet. Wait for the WLAN LED ( ) to turn on. If none of the LEDs turn on, make sure the Power On/Off button is in the ON position (pushed in). (not included) Step 5: Connect the ROUTER to your computer ( ). Use another ethernet cable to establish a wired connection as shown in this diagram. Optionally, connect wirelessly by using the preconfigured wireless security settings located on the bottom label. Laptop or Desktop Computer Step 6: Open a browser. If the web page doesn't display, close and re-open the browser to http://routerlogin.net in the address bar, or check the "Troubleshooting" section on the back of this installation guide.