NordicTrack Apex 5100 Treadmill English Manual - Page 7

4. Insert two Handrail Bushings (94) into the right Upright (83). Turn the Handrail Bushings so they fit against the 4 Upright as shown in the inset drawing. Insert two Handrail Bolts (96) with Handrail Washers (95) into the Handrail Bushings (94), the right Upright (83), and the right Handrail Spacer (92). Lift up the right Handrail (73) and align the Bolts with the holes in the Handrail. Next, thread the Bolts into the Handrail. Do not tighten the Bolts yet. Attach the left Handrail (not shown) in the same way. Tighten all four Handrail Bolts (96). 73 92 83 94 95 94 95 96 5. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet from damage, place a mat under the treadmill. If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated Screws from the Console Back (120). Imortant: The Screws may be different lengths. Keep track of which Screws were removed from which holes. 2. See drawing 2a. Peel the paper off the pad on the bottom of the Receiver (A). Turn the Receiver so the cylinder is on the side shown, and press the Receiver into the bottom of the Console Base (79) in the indicated location. See drawing 2b. Connect the Short Jumper Wire (B) to the wire on the Receiver (A). Connect the other end of the Jumper Wire to the PULSE jack on the back of the Console (80). Note: The included Long Jumper Wire and Wire Tie are not needed and can be discarded. Make sure that no wires are pinched. See step 1 above. Reattach the Console (80) with the Screws. Note: If the Screws are not put in the correct locations, the Console will be damaged. 1 120 Screws 2a 79 80 A Cylinder 2b 80 PULSE Jack BA 7