NordicTrack Audiostrider 900 Elliptical English Manual - Page 13

HOW TO USE THE ELLIPTICAL EXERCISER HOW TO PLUG IN THE POWER CORD DANGER: Improper connection of the equipment-earthing conductor can result in an increased risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the product is properly earthed. Do not modify the plug provided with the product-if it will not fit the outlet, have a proper outlet installed by a qualified electrician. HOW TO FOLD AND UNFOLD THE ELLIPTICAL EXERCISER When the elliptical exerciser is not in use, the frame can be folded out of the way. First, lift the latch under each pedal arm, and lift the pedal arms off the sleeves on the crank arms. Sleeve Pedal Arm This product must be earthed. If it should malfunc- tion or break down, earthing provides a path of least Latch resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-earthing conductor and an earth- ing plug. If the power cord is damaged, it must be Next, raise the pedal arms until they touch the mag- replaced with a manufacturer-recommended nets on the upper body legs; the magnets will hold the power cord. pedal arms in place. Then, hold the handle and lift the frame until it locks in a vertical position. Two power cords are included. 1 Select the one that will fit your Socket on Elliptical Exerciser Magnet outlet. Refer to drawing 1, and Handle Pedal Arm plug the indicated end of the power cord into the sock- U et at the back of the elliptical exer- Latch ciser. Button Refer to drawing 2. Plug the power 2 cord into an appro- Outlet priate outlet that is properly installed and earthed in accordance with all local codes and ordinances. Note: In Italy, an adap- tor (not included) must be used between the power cord and the outlet. IMPOR- TANT: The elliptical exerciser is not compatible with GFCI-equipped outlets. UK To use the elliptical exerciser, first hold the handle, press the latch button, and lower the frame. Next, pull the pedal arms off the magnets on the upper FR/SP body legs. Then, lift the latches under the pedal arms, and set the pedal arms on the sleeves on the crank arms. Release the latches, and make sure that the pedal arms are securely connected to the crank arms. 13FR/SP