NordicTrack C 900 I Treadmill English Manual - Page 31
Troubleshooting - treadmill problems
View all NordicTrack C 900 I Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
TROUBLESHOOTING Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual. SYMPTOM: The power does not turn on a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 21). Use only a surge suppressor that meets all of the specications described on page 21. IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets. b. After the power cord has been plugged in, make sure that the key is inserted into the console. c. Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for ve minutes and then press the switch back in. c. Remove the key from the console, and then reinsert it. d. If the treadmill still will not run, please see the front cover of this manual. SYMPTOM: The console displays remain lit when you remove the key from the console a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE SETTINGS MODE on page 28 to turn off the demo mode. SYMPTOM: The displays of the console do not function properly a. Remove the key from the console and UNPLUG THE POWER CORD. Remove the ve #8 x 3/4" Screws (2). Carefully pivot the Motor Hood (65) off. c Tripped Reset a 65 2 2 SYMPTOM: The power turns off during use 2 a. Check the power switch (see the drawing above). If the switch has tripped, wait for ve minutes and then press the switch back in. b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for ve minutes, and then plug it back in. 31