NordicTrack C3 Si Bike User Manual - Page 7

3. While another person holds the Upright (2) near the Frame (1), locate the wire tie in the Upright. See the inset drawing. Tie the lower end of the wire tie to Pulse Extension Wire (79) and to the Main Wire Harness (43). Next, pull the other end of the wire tie upward out of the top of the Upright (2). Then, untie and discard the wire tie. Tip: Do not allow the ends of the wires to fall into the Upright. Use a piece of tape or an elastic band to hold the wires in place until step 6. Tip: Avoid pinching the wires. Attach the Upright (2) to the Frame (1) with an M10 x 63mm Bolt Set (62). 3 43 79 2 Wire Tie 43 79 62 1 62 Avoid pinching the wires 4. Identify the Right and Left Handlebars (59, 60), which are marked with "Right" and "Left" stickers. 4 Orient the Right and Left Handlebars (59, 60) 60 so that the hexagonal holes are in the indi- cated locations. Attach each Handlebar (59, 60) to the Upright (2) with two M8 x 38mm Button Bolts (72) and two M8 Locknuts (61). Make sure that the Locknuts are in the hexagonal holes. Hexagonal 61 Holes 61 72 2 59 72 7