NordicTrack Cx 990 Elliptical English Manual - Page 9

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you have purchased the optional chest pulse sensor (see page 21), follow the steps below to install the receiver included with the optional chest pulse sensor. 1. Look under the Console (17) and locate the access cover. Remove the access cover. 17 2. Hold the receiver in the position shown, with the small cylinder at the top. Using the two screws included with the chest pulse sensor, attach the receiver to the two plastic posts (not shown) inside the access opening in the back of the Console (17). 3. Connect the wire on the receiver to the indicated wire on the Console (17). Make sure that the connectors on the wires snap together. Discard the other wires included with the chest pulse sensor. 4. Reattach the access cover to the Console (17). Cylinder Receiver Access Cover Screws 9