NordicTrack E 1000 Elliptical English Manual - Page 7

3. Tip: Avoid pinching the Wire Harnesses (97, 3 54). Start all screws before tightening any of them. While another person holds the Upright (6) near the Frame (1), connect the Upper Wire Harness (97) to the Lower Wire Harness (54). Attach the Upright (6) to the Frame (1) with five 5/16" x 1" Patch Screws (81) and five 5/16" Split Washers (105). 6 81 105 81 Avoid pinching the Wire Harnesses (97, 54) 97 54 1 105 81 4. Apply a generous amount of the included grease to the Pivot Axle (33) and to two 5/8" Wave Washers (102). 4 104 97 81 Tip: Avoid pinching the Upper Wire Harness (97). Insert the Pivot Axle (33) into the Upright (6). Then, slide a 5/8" Wave Washer (102) onto each end of the Pivot Axle. 94 102 Next, orient an Upper Body Leg (12) as shown. Make sure that the M10 x 78mm Patch Screw (71) in the lower end of the Upper Body Leg is facing away from the Upright (6). Slide the Upper Body Leg (12) onto the Pivot Axle (33). Attach the Upper Body Leg with a 5/16" x 1" Patch Screw (81), an Outer Large Axle Cover (94), and a 5/16" Washer (104). 12 6 71 Attach the other Upper Body Leg (12) in the same way. Grease 33 102 104 94 81 12 71 7