NordicTrack E7 Sv Front Drive Elliptical Canadian English Manual - Page 10

10. Attach the Right Pedal Arm (58) to the Right Pedal Bracket (64) with two M10 x 45mm Patch 10 Screws (99). Repeat this step for the Left Pedal Arm (44). 44 64 58 99 11. Identify the Right Pulse Bar (9), which is marked with a "Right" sticker. See the inset drawing. Locate the wire tie in the Upright (4). Tie the lower end of the wire tie to the Pulse Wire (63) in the Right Pulse Bar (9). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Slide the Right Pulse Bar (9) onto the right side of the Upright (4). Make sure that the hexagonal holes are in the indicated location. Tip: Avoid pinching the wires. Attach the Right Pulse Bar (9) with two M8 x 38mm Bolts (96) and two M8 Locknuts (102). Make sure that the Locknuts are in the hexagonal holes. Repeat this step for the Left Pulse Bar (8). 11 Avoid pinching the wires 110 Wire Tie 63 8 102 63 4 9 Hexagonal Holes 96 Wire Tie 63 10