NordicTrack Incline Trainer X11 English Manual - Page 7

ASSEMBLY • To watch an assembly video, go to http://productvideo.co/ assembly/nordictrack or use your mobile phone or smartphone to read the QR code at the right. If there is an oily substance on the incline trainer, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 6. • Assembly requires two persons. • Assembly requires the following tools: • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the incline trainer. This is normal. the included hex keys Phillips screwdriver To avoid damaging parts, do not use power tools. 1. Make sure that the power cord is unplugged. 1 Identify the right Upright (77), which has a wire tie in it. Hold the Upright near the right side of the incline trainer.  See the inset drawing. Tie the wire tie in the right Upright (77) around the end of the Upright Wire (78). Then, pull the other end of the wire tie until the Upright Wire is routed out of the top of the Upright. Wire Tie 77 Wire Tie 78 78 77 7