NordicTrack Sl 528 English Manual - Page 8
on the Left Pedal 22. Adjust the Right Pedal Strap - battery
View all NordicTrack Sl 528 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
7. The Console (4) requires four "D" batteries (not includ- 7 ed); alkaline batteries are recommended. Remove the battery cover from the bottom of the Console. Next, insert four batteries into the battery compartment; make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Reattach the battery cover. 4 Batteries 8. While another person holds the Console (4) near the Handlebar (3), connect the Upper Wire Harness (42) to the wire harness on the Console, and connect the Pulse Wire (75) to the pulse wire on the Console. Insert the excess wiring into the Upright (2). Attach the Console (4) to the Handlebar (3) with four M4 x 16mm Round Head Screws (80). Be careful to avoid pinching the wires and wire harnesses. 9. Thread an M6 x 8mm Button Screw (59) into the front hole in the Seat Post (8). Next, orient the Seat Carriage (11) as shown, and slide it onto the Seat Post. Thread the other M6 x 8mm Button Screw into the rear hole in the Seat Post. Next, attach the Seat (9) to the Seat Carriage (11) with four M8 Nylon Locknuts (79) and four M8 Split Washers (55). (Note: The Nylon Locknuts and the Split Washers may be pre-attached to the Seat.) Thread the Seat Knob (10) clockwise into the right side of the Seat Carriage until it is tight. Battery Cover 8 80 9 42 3 75 2 Front 59 Hole 8 11 55 79 4 9 10 55 79 10.Identify the Left Pedal (22), which is marked with an 10 "L." Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the Left Crank Arm (24). Tighten the Right Pedal (not shown) clockwise into the Right Crank Arm (not shown). Important: Tighten both Pedals as firmly as possible. After using the exercise cycle for one week, retighten the Pedals. 25 24 Adjust the Left Pedal Strap (25) to the desired position, and press the end of the Left Pedal Strap onto the tab on the Left Pedal (22). Adjust the Right Pedal Strap (not shown) in the same way. 22 Tab 11.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor. 8