NordicTrack Sl700 English Manual - Page 7

8. Identify the Left Pedal (22), which is marked with an "L." Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the Left Crank Arm (24). Tighten the Right Pedal (not shown) clockwise into the Right Crank Arm. Important: Tighten both Pedals as firmly as possible. After using the exercise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tightened. 8 25 22 Identify the Left Pedal Strap (25), which is marked with an "L." Attach the Left Pedal Strap to the Left Pedal (22), and adjust it to the desired position. 24 Adjust the Right Pedal Strap (not shown) in the same way. 9. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor. INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor. 1. Remove the four recessed screws (not shown) from the underside of the Console (4). Do not remove the screws attaching the Console to the metal plate on the Handlebar (3). Push the two water bottle holders up out of the Console (4). Carefully lift the fan and the top of the Console (4) in the locations shown at the right; do not let the fan slide out of the top of the Console. Note: It will be necessary to turn the top of the Console slightly to lift it past the Handlebar (3). 1 Water Bottle Holder 3 Lift Here Water Bottle Holder 4 2. While another person holds the top of the Console (4) and the fan in a vertical position, slide the receiver onto 2 the indicated plastic pin on the Console; make sure that the receiver is oriented exactly as shown. Locate the two small screws included with the chest pulse sensor. Attach the receiver to the Console with the two screws as shown. Connect the wire on the receiver to the indicated wire on the Console (4). Refer to step 1 above. Lower the top of the Console (4) and the fan. Make sure that no wires are pinched. Reattach the top of the Console with the four screws removed in step 1. Discard any extra wires included with the chest pulse sensor. 4 Screws Receiver Pin Wire 7