NordicTrack T 5.5 Treadmill English Manual - Page 11

8. IMPORTANT: To avoid damaging the Pulse Crossbar (31), do not use power tools and do not overtighten the #10 x 3/4" Screws (13). Orient the Pulse Crossbar (31) as shown. Start one #10 x 3/4" Screw (13) with one #10 Star Washer (11) into each end of the Pulse Crossbar and each of the Handrails (71, 72). Then, start another #10 x 3/4" Screw and #10 Star Washer into each end of the Pulse Crossbar. Start all four Screws, and then tighten them. Insert the Console Frame (87) into the Handrails (71, 72). Attach the Console Frame with four 1/4" x 1" Screws (9). Start all four Screws, and then tighten them. Be careful not to pinch the Upright Wire (70). 8 87 9 70 13 11 71 13 9 11 31 72 9. Firmly tighten the two 5/16" x 1" Bolts (7) and the four 5/16" x 1" Flat Head Screws (10) (only one 9 side is shown). With the help of a second person, hold the console assembly near the Left Handrail (71) and the Right Handrail (not shown). Connect the ground wire from the console assembly to the Console Ground Wire (89). Next, connect the Upright Wire (70) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Then, remove the wire tie from the Upright Wire. Ground Wire 89 Console Wire 71 70 Console Assembly Console Wire 70 7 10 Wire Tie 11