NordicTrack T7 Ze Treadmill English Manual - Page 9
The Console May Be Damaged When
View all NordicTrack T7 Ze Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
7. Set the console assembly face down on a soft 7 surface to avoid scratching the console assem- Console bly. Hold the Right Handrail (95) near the con- Wire sole assembly. Next, insert the console wire into the large hole in the Right Handrail and out of 1 the top as shown. If necessary, use needlenose 95 pliers to pull the console wire out. Attach the Right Handrail (95) and the Left Handrail (not shown) with four #8 x 3/4" Screws (1) (only two are shown). Make sure that no wires are pinched. Start all four Screws before tightening any of them; do not overtighten the Screws. Console Assembly 8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star 8 Washer (33) into the bracket and the Handrail Crossbar (94) on each side of the console as- sembly (only one side is shown). Remove the wire tie from the console wire. Console Wire Wire Tie 5 33 Bracket Console Assembly 94 9. Have a second person hold the console assembly near the Right Upright (78) and the Left Upright (not shown). Connect the Upright Wire (38) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, remove the long tie from the Upright Wire. Set the console assembly on the Right Upright (78) and the Left Upright (not shown). Be careful not to pinch the wires. 9 Console Assembly Console Wire 78 38 Long Tie Console Wire 38 9