Oki B6100n User Guide:RS-232C/RS-422 Serial Interface Option - Page 22

3-2 RS-232C/RS-422 Serial Interface Option Control Panel Error Messages About this Chapter This chapter discusses troubleshooting error messages appearing on the printer's control panel. Sources of help, information and technical support are also discussed. Control Panel Error Messages The format of control panel error messages is: NETx: ERROR y where x indicates the network slot where the serial interface is installed and where y reflects the error number as shown below: Error No. 1 Description Overrrun Error 2 Parity Error 3 Framing Error 4 Flow Control Error Action Required Verify that all DTS, RTS and XON settings within the SERIAL SETUP menu are configured correctly. Check the pinout assignments of cabling between the printer and the host. Verify that the PARITY setting within the SERIAL SETUP menu is configured correctly. Check the pinout assignments of cabling between the printer and the host. Verify that the SERIAL MODE, BAUD RATE, DATA BITS, STOP BITS and PARITY settings within the SERIAL SETUP menu are configured correctly. Verify that all DTS, RTS and XON settings within the SERIAL SETUP menu are configured correctly. Check the pinout assignments of cabling between the printer and the host. Example An error message of: NET2: ERROR3 indicates that the serial interface which is located in network slot 2 has experienced a framing error. Obtaining Help and Information Several sources of help and information are available, depending on the type of help you need: