Oki B6200 B6200/6300 Series Setup Guide - English - Page 21

Installing The Duplex Unit

Get Oki B6200 PDF manuals and user guides View all Oki B6200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

INSTALLING THE DUPLEX UNIT You can install a duplex unit option on this printer. If a face up tray has been fitted, remove it by reversing the steps in "Installing the Face Up (Rear) Tray" on page 14 before installing the duplex unit and refit it when the duplex unit has been installed. 1. Remove the duplex unit cover by pushing the two tabs as shown in the diagram (1). Next, remove the connector cap at the top right of the back of the printer (2). 2. Insert the right and left tabs at the bottom of the duplex unit into the holes at the back of the printer, and then align the top part of the duplex unit with the printer. Ensure that the connector of the duplex unit is connected to the connector of the printer. INSTALLATION AND RELOCATION PROCEDURE > 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
INSTALLATION AND RELOCATION PROCEDURE > 21
INSTALLING THE DUPLEX UNIT
You can install a duplex unit option on this printer. If a face up tray has
been fitted, remove it by reversing the steps in
“Installing the Face Up
(Rear) Tray” on page 14
before installing the duplex unit and refit it when
the duplex unit has been installed.
1.
Remove the duplex unit cover by pushing the two tabs as shown
in the diagram (1).
Next, remove the connector cap at the top right of the back of the
printer (2).
2.
Insert the right and left tabs at the bottom of the duplex unit into
the holes at the back of the printer, and then align the top part of
the duplex unit with the printer.
Ensure that the connector of the duplex unit is connected to the
connector of the printer.