Oki PM4410 Guide: User's, PM4410 (English) - Page 20
being used, the printhead will print, Caution! If the width is set
View all Oki PM4410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Item Page Width Description Change to 8" if you are using 9-inch continuous forms. For continuous forms less than 9 inches wide, the page width must be set using software. Caution! If the page width is set narrower than the continuous forms being used, the printhead will print directly on the platen: this can damage the printhead. Emulations Group(s) All Rear Feed, Front Feed Parity Sets the type of parity your system uses. Pin 18 Sets the signal on pin 18 of the parallel interface to +5 volts or to open. Pitch Sets the character width in characters per inch. Ppr Out Override Paper Out Override: Senses when less than 1" (25 mm) of paper remains and stops printing. Change to Yes to override the sensor. Caution!! This can cause loss of data and damage the printhead! Print DEL Code Change to Yes if you wish to print the DEL code (decimal 27) as a solid box. Print Mode Sets the typeface used: Utility, NLQ (Near letter Quality) Courier, NLQ (Near Letter Quality) Gothic, or HSD (High Speed Draft). Print Suppress If you wish to enable the print suppress command, change the setting to Yes. If you select Yes, the printer will ignore all data after it receives the print suppress command. Prop. Spacing Change to yes if you wish to engage proportionally spaced printing. Protocol Switch to X-ON/X-OFF if that is the serial interface protocol you are using. Rcv. Buffer Sets the size of the receive buffer. All All All All ML only All All All All All Serial I/F Parallel I/F Font Set-Up Set-Up Font Set-Up Font Serial I/F Set-Up 20