Onkyo A-905TX User Manual English - Page 14

Connecting to components other than the Separate Collection Series Connecting the cables If your other components are made by ONKYO and those components are equipped with connectors, you can control the -connected components with the supplied remote controller. Before connecting • The unit must be connected in the system hookups for control operations. • Each component has two connectors. There is no difference between these connectors. • The components may be connected in any order. • The hookups on the previous page are necessary independently of the system hookups. The illustration below is an example of a hookup. Connections Tuner Amplifier - this unit MD recorder Stereo cassette tape deck CD player cable (supplied with every ONKYO component that has connectors except for the amplifier and receiver) AC outlet connection You can connect the power cord from another audio device to the rear of the A905TX. Since the AC outlet on the unit is a SWITCHED type outlet, you can use the POWER switch to turn on/off the power to both the A-905TX and the connected audio device. The shape and capacity of the AC outlet may differ depending on the area of purchase. Make sure that the capacity of other components connected to this unit does not 14 exceed the capacity that is printed on the rear panel. L OUT(REC) IN(PLAY) L L SPEAKERS R R TUNER LINE/DVD TAPE REMOTE CONTROL R OUT(REC) IN(PLAY) OUT(REC) IN(PLAY) L R OUT IN SUBWOOFER CDR/PC CD MD PROCESSOR PRE OUT CAUTION: SPEAKER IMPEDANCE 4 OHMS MIN./SPEAKER AC OUTLET AC 230-240V 50Hz SWITCHED 100W MAX. 230-240 V, 50 Hz models 120 V, 60 Hz models Capacity is 100 watts. Capacity is 120 watts.