Onkyo A-9755 Owner Manual - Page 14
Enjoying Audio Sources - reset
View all Onkyo A-9755 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Enjoying Audio Sources Turning On the A-9755/A-9555 POWER STANDBY indicator STANDBY ON Note: To shut down the A-9755/A-9555 completely, set the [POWER] switch to the OFF position ( ). Selecting Speaker 1 A-9755/ A-9555 Press the [POWER] switch. The A-9755/A-9555 retains the power mode (on/standby) in which the amplifier was the last time you turned off the system. Notes: • The A-9755/A-9555 is shipped with the [POWER] switch in the OFF position ( ). When the power cord is connected for the very first time or the [POWER] switch is set to ON ( ) position, the A-9755/A-9555 will turn on. • When it's turned on, the A-9755/A-9555 outputs no sound for about five seconds. This allows the circuits to stabilize. 2 Remote controller To set the A-9755/A-9555 to Standby, press the [STANDBY] button on the remote controller. The STANDBY indicator lights up. To turn the A-9755/A-9555 on, press the [ON] button on the remote controller. The STANDBY indicator goes off. If the A-9755/A-9555 is connected to other components via , press the remote controller's [ON] button once to turn on the A-9755/A-9555, and press it again to turn on the other components. Turning on all system components simultaneously: You can set the A-9755/A-9555 so that all connected components are turned on with just one press of the remote controller's [ON] button. To do this, turn on the A-9755/A-9555, and then press and hold the remote controller's [ON] button for 16 seconds until the A-9755/A-9555 switches to Standby mode. You will then be able to turn on the A-9755/A-9555 and all system components with just one press of the remote controller's [ON] button. If you want to restore the setting to the original state, reset the A-9755/A-9555. For information about how to reset, see "How to reset" on page 19. 14 You can select which set of speakers outputs sound. OFF: Select "OFF," if you do not connect any speaker. A: To output sound from the speakers connected to the SPEAKERS A terminals, turn the SPEAKERS selector to the "A" position. B: To output sound from the speakers connected to the SPEAKERS B terminals, turn the SPEAKERS selector to the "B" position. A+B: To output sound from all connected speakers, turn the SPEAKERS selector to the "A+B" position. Note: If the Volume indicator flashes quickly, make sure that the speakers are connected correctly.