Optoma DV11 User Manual - Page 55

Replacing the Lamp - bulb

Get Optoma DV11 PDF manuals and user guides
UPC - 079643524167
View all Optoma DV11 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 55 highlights

English MAINTENANCE Replacing the Lamp The projector automatically detects the lamp life. When the lamp life is nearing the end of use, you will receive a warning message. When you see this message, please contact your local reseller or service center to change the lamp as soon as possible. Make sure the projector has been cooled down for at least 30 minutes before changing the lamp. Warning: Lamp compartment is hot! Allow it to cool down before changing lamp! 1 3 2 4 Warning: To reduce the risk of personal injury, avoid dropping the lamp module or touching the lamp bulb. If dropped, the bulb may shatter and cause injury. Lamp Replacing Procedure: 1. Turn off the power to the lamp by pressing the [Power] or [Stand By] button. 2. Allow the projector to cool down at least 30 minutes. 3. Disconnect the power cord. 4. Use screwdriver to remove the screw from the cover.  5. Remove the cover.  6. Unscrew 2 screws from the lamp module.  7. Pull out the lamp module.  To replace the lamp module, reverse the above mentioned steps. DVD Projector * 55

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
DVD Projector
*
55
E
nglish
MAINtENANcE
Replacing the Lamp
The projector automatically detects the lamp life.
When the lamp life
is nearing the end of use, you will receive a warning message.
Warning:
Lamp com-
partment is hot!
Allow
it to cool down before
changing lamp!
Lamp Replacing Procedure:
1.
Turn off the power to the lamp by pressing the [Power] or
[Stand By] button.
2.
Allow the projector to cool down at least 30 minutes.
3.
Disconnect the power cord.
4. Use screwdriver to remove the screw from the cover.
5.
Remove the cover.
6.
Unscrew 2 screws from the lamp module.
7.
Pull out the lamp module.
To replace the lamp module, reverse the above mentioned
steps.
Warning:
To reduce
the risk of personal
injury, avoid dropping
the lamp module or
touching the lamp bulb.
If dropped, the bulb
may shatter and cause
injury.
When you see this message, please contact your local reseller or service
center to change the lamp as soon as possible. Make sure the projec-
tor has been cooled down for at least 30 minutes before changing the
lamp.
1
2
3
4