Optoma DX621 User Guide - Page 38

Other Problems, Projector Status Indication

Get Optoma DX621 PDF manuals and user guides
UPC - 796435416843
View all Optoma DX621 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Appendices Other Problems The projector stops responding to all controls  If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power. Lamp burns out or makes a popping sound  When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the "Replacing the Lamp" section on pages 40-41. Projector Status Indication LED lighting message Message Standby State (Input power cord) Power on (Warming) Power LED (Red) Power LED (Blue) Flashing (0.5 sec off, 0.5 sec on) Lamp lighting Power off (Cooling) Error (Over Temp.) Steady light  Error (Fan fail) No light  Error (Lamp fail) Flashing (1 sec off, 1 sec on) Flashing (0.5 sec off, 2.0 sec on) Flashing (0.5 sec off, 0.5 sec on) Flashing (1 sec off, 1 sec on)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
38
English
Appendices
Other Problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and
wait at least 60 seconds before reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the “Replacing the Lamp” section on
pages 40-41.
Projector Status Indication
LED lighting message
Message
Power LED
Power LED
(Red)
(Blue)
Standby State
(Input power cord)
Power on (Warming)
Flashing
(0.5 sec off, 0.5 sec on)
Lamp lighting
Power off (Cooling)
Flashing
(1 sec off, 1 sec on)
<10 sec to off
Error (Over Temp.)
Flashing
(1 sec off, 1 sec on)
Error (Fan fail)
Flashing
(0.5 sec off, 2.0 sec on)
Error (Lamp fail)
Flashing
(0.5 sec off, 0.5 sec on)
Steady light
No light