Optoma EH1020 User's Manual - Page 46

Projector Status Indication

Get Optoma EH1020 PDF manuals and user guides
UPC - 796435411503
View all Optoma EH1020 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Appendices Steady light  No light  The projector stops responding to all controls  If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power.  Check that "Keypad Lock" is not activated by trying to control the projector with the remote control. Lamp burns out or makes a popping sound  When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the "Replacing the Lamp" section on pages 48-49. Projector Status Indication LED lighting message Message ON/STANDBY LED (Green/Amber) Standby State (Input power cord) Amber Power on (Warming) Flashing Green Temp-LED (Red) Lamp lighting Green Power off (Cooling) Error (Over Temp.) Error (Fan fail) Error (Lamp fail) Flashing Green Flashing Amber Flashing Amber Flashing Amber Flashing Lamp-LED (Red) English 46

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
46
English
Appendices
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and
wait at least 60 seconds before reconnecting power.
Check that “Keypad Lock” is not activated by trying to control the
projector with the remote control.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the “Replacing the Lamp” section on
pages 48-49.
Projector Status Indication
LED lighting message
Steady light
No light
Message
ON/STANDBY
LED
Temp-LED
Lamp-LED
(Green/Amber)
(Red)
(Red)
Standby State
(Input power cord)
Amber
Power on (Warming)
Flashing
Green
Lamp lighting
Green
Power off (Cooling)
Flashing
Green
Error (Over Temp.)
Flashing
Amber
Error (Fan fail)
Flashing
Amber
Flashing
Error (Lamp fail)
Flashing
Amber