Optoma TW536 User's Manual - Page 13

Powering the projector On/Off

Get Optoma TW536 PDF manuals and user guides
UPC - 796435411282
View all Optoma TW536 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Installation Powering the projector On/Off Powering On the Projector . Remove the lens cap.  2. Securely connect the power cord and signal cable. When connected, the Power LED will turn red. 3. Turn on the lamp by pressing "POWER" button either on the top of the projector or on the remote. The Power LED will now turn Green.  The startup screen will display in approximately 0 seconds. The first time you use the projector, you can select your preferred language after the startup screen displays. 4. Turn on and connect the source that you want to display on the screen (computer, notebook, video player, etc). The projector will detect the source automatically. If not, push menu button and go to "OPTIONS". Make sure that the "Source Lock" has been set to "Off".  If you connect multiple sources at the same time, press the "SOURCE" button on the control panel or direct source keys on the remote control to switch between inputs. 2 Power/Standby E N H A WI NC DES ED N E E R C  Turn on the projector first and then select the signal sources.  Lens Cap 3 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
±3
English
Installation
Powering On the Projector
±. Remove the lens cap.
2. Securely connect the power cord and signal cable. When
connected, the Power LED will turn red.
3. Turn on the lamp by pressing “POWER” button either on the
top of the projector or on the remote. The Power LED will
now turn Green.
The startup screen will display in approximately ±0 seconds.
The first time you use the projector, you can select your
preferred language after the startup screen displays.
4. Turn on and connect the source that you want to display
on the screen (computer, notebook, video player, etc). The
projector will detect the source automatically. If not, push
menu button and go to “OPTIONS”.
Make sure that the “Source Lock” has been set to “Off”.
If you connect multiple sources at the same time, press the
“SOURCE” button on the control panel or direct source keys
on the remote control to switch between inputs.
Powering the projector On/Off
Turn on the
projector first and
then select the
signal sources.
ENHANCED
Lens Cap
±
Power/Standby
2