Optoma TWR1693 User's Manual - Page 56
Replacing the Lamp, Loosen the two captive screws on the lamp compartment cover.
UPC - 796435117061
View all Optoma TWR1693 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Appendices Replacing the Lamp The projection lamp should be replaced when it burns out. It should only be replaced with a certified replacement part, which you can order from your local dealer. Important: 4 The lamp contains a certain amount of mercury and should be disposed of according to local ordinance regulations. 4 Avoid touching the glass surface of the new lamp, doing so may shorten its operation life. Warning: 4 Be sure to turn off and unplug the projector at least an hour before replacing the lamp. Failure to do so could result in a severe burn. English 1. Loosen the two captive screws on the lamp compartment cover. 2. Open the lamp compartment cover. 3. Remove the two screws from the lamp module. 4. Lift the module handle up. 5. Replace the lamp module. 6. Reverse steps 1 to 5 to install the new lamp module. After replacing the lamp, the lamp hours counter must be reset. See page 47 for more information. 56