Oreck DTX1300 Owners Guide - Page 6
eplacing, ilter, xhaust
View all Oreck DTX1300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ENGLISH Replacing Filter Bag Replacing Motor Filter BAG FULL INDICATOR Check bag frequently or when dustbag full indicator indicates dust bag is full. Note: If picking up heavy debris, change bag more frequently. Unplug unit from wall outlet. Remove the dustbag and carrier to access the motor filter grill. Using the tab located at top of filter grill, lift filter grill out of unit. Switch the unit off. Unplug unit from wall outlet. Open the cover by lifting the latch in front of the intake. Remove filter from grill and replace with new filter. Change the motor filter every fifth dustbag replacement. Remove dust bag by raising handle on bag carrier and lifting carrier out. Remove the bag from carrier by pulling the cardboard tag. The Saniseal™ dust seal will close automatically. Insert a new bag into carrier by sliding cardboard into slots on carrier until bag is fully inserted. Bend rear part of dustbag downwards. Replacing Exhaust Filter Unplug unit from wall outlet. Remove exhaust grill from back of unit by pressing down and pulling out on the tab located at the top of the grill. Discard used exhaust filter. Place new filter in grill. Set grill tabs in slots. Press top of grill to snap closed. The exhaust filter should be changed with every fifth dustbag replacement. Note: Exhaust filter not needed if Advanced Hepa Filter was purchased. ADVANCED HEPA FILTER INSTALLATION: Replace the carrier into the unit. Close the cover by pressing it down until it latches. The cover cannot be closed if a bag is not present or inserted properly. Remove exhaust grill. Install Advanced Hepa Filter by aligning tabs in slots and pressing top to snap closed. After filter has snapped into place, push filter upwards. Note: Replace Hepa Filter once a year or every fifth dust 6 bag replacement.