Oreck U2007RH Owners Guide - Page 5

Parts List, Assembly, Operating Instructions - air cleaner

Get Oreck U2007RH PDF manuals and user guides View all Oreck U2007RH manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

ENGLISH Parts List To assist you in identifying components of your vacuum, the parts have been numbered as follows: 1 Handle section, upper 2 Tube, lower 3 Power head 4 Outer bag 5 Paper filter dust bag 6 Power cord 10 11 9 12 1 17 7 Retaining spring 16 8 Bag tension bar 5 4 13 9 Zip fastener 10 On/off switch 11 Cord hook 2 6 12 Plastic loop/cable clamp 13 Connector assembly 14 Fan housing 15 Cord assembly 87 14 15 16 Handle Brace 17 Cord Strain Relief 3 Assembly fig. 1 Before assembling appliance, remove two screws from the connector assembly. Remove cardboard insert by pulling upward. fig. 2 Slide upper handle section over matching section of the connector assembly. Place brace against handle and connector assembly aligning screw holes. Insert short screw into top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose. fig. 3 Attach cord to cord clip by pressing above and below clip ensuring the cord is fully rested in clip. Operating Instructions Make sure the disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet. Press the On(l) - OFF(O) switch on handle assembly when ready to operate. Choose from the low and high speed settings by pressing the ON/LOW (l) ON/HIGH (ll) - OFF (O) switch on handle assembly when ready to operate. General Information The performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service read the instructions and keep them handy for future reference. Operating Recommendations This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You'll love the way it cleans, gets under things, and it's SO lightweight and easy to use. The following are a few simple suggestions regarding its operation: 1. When inserting a new disposable paper filter dust bag- FIRST PUFF OUT and OPEN THE BAG. 2. When the disposable filter dust bag is full, REPLACE IT. 3. If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service. 4. Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor suction fan and its housing. 5. WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not covered under warranty. 6. REPLACE THE BELT EVERY 6 MONTHS. 7. Change the disposable filter dust bag at least once a month-even if it is not full! The collected dust in the dust bag can cause odor, attract moisture, act as a breeding area and can affect the efficiency of the cleaner. 8. DO NOT run the vacuum cleaner over cord. The revolving brush could damage the cord. 9. Use caution when vacuuming over area rug edges and fringe. Disposable Paper Filter Dust Bags Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the paper bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the paper bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner's power. Increase the CLEANING POWER of your cleaner by changing the bag often. To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE DUST BAG. Be sure the disposable paper filter dust bag is installed properly. All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner. Using bags other than genuine ORECK disposable bags will affect the cleaning ability of your cleaner and could cause damage to it. The Belt The belt on your vacuum cleaner controls the speed of the revolving brush and is very important for the effective operation of the cleaner. If the belt becomes stretched or cut, it will cause the revolving brush to stop completely or slow down. See instructions in the manual for replacing belt. An extra belt is stored in the baseplate of your cleaner. When buying replacement belts, use ONLY ORECK genuine belts. Belts other than Oreck belts will not operate the revolving brush correctly and may create undue stress which will cause damage to the motor and brush bearings. Using belts other than ORECK belts will void the warranty. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
1
2
3
4
9
10
11
14
15
16
17
12
13
5
6
7
8
Parts List
To assist you in identifying components of your vacuum, the
parts have been numbered as follows:
1
Handle section, upper
2
Tube, lower
3
Power head
4
Outer bag
5
Paper filter dust bag
6
Power cord
7
Retaining spring
8
Bag tension bar
9
Zip fastener
10
On/off switch
11
Cord hook
12
Plastic loop/cable clamp
13
Connector assembly
14
Fan housing
15
Cord assembly
16
Handle Brace
17
Cord Strain Relief
Assembly
fig. 1
Before assembling appliance, remove two screws from
the connector assembly.
Remove cardboard insert by
pulling upward.
fig. 2
Slide upper handle section over matching section of the
connector assembly. Place brace against handle and
connector assembly aligning screw holes. Insert short
screw into top hole and long screw into the bottom hole
then tighten firmly until handle is no longer loose.
fig. 3
Attach cord to cord clip by pressing above and below clip
ensuring the cord is fully rested in clip.
Operating Instructions
Make sure the disposable paper filter dust bag is in place.
DO
NOT operate the cleaner without a paper filter dust bag. Plug the
power cord into an electrical outlet.
Press the On(l) - OFF(O)
switch on handle assembly when ready to operate.
Choose
from the low and high speed settings by pressing the ON/LOW
(l) ON/HIGH (ll) - OFF (O) switch on handle assembly when
ready to operate.
General Information
The performance of your new cleaner greatly depends upon
care and maintenance. The instructions in this manual will guide
you in performing basic care and maintenance. To obtain the
most satisfying years of service read the instructions and keep
them handy for future reference.
Operating Recommendations
This new ORECK XL High-Speed Upright is one of the finest,
fastest, and strongest units in its class. You’ll love the way it
cleans, gets under things, and it’s SO lightweight and easy to
use.
E
N
G
L
I
S
H
The following are a few simple suggestions regarding its
operation:
1. When inserting a new disposable paper filter dust bag—
FIRST PUFF OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or
makes an unusual noise, STOP OPERATION and service.
4. Although your upright will pick up pins, paper clips, and
other small objects, it is recommended that these be
removed from the floor before you vacuum. Failure to do so
may result in permanent damage to the motor suction fan
and its housing.
5.
WARNING:
Do not use your vacuum cleaner on damp or
wet surfaces. This will cause damage to the vacuum
cleaner and is dangerous to the user. Damage caused by
use on wet or damp surfaces is not covered under
warranty.
6.
REPLACE THE BELT EVERY 6 MONTHS.
7. Change the disposable filter dust bag at least once a
month—even if it is not full! The collected dust in the dust
bag can cause odor, attract moisture, act as a breeding
area and can affect the efficiency of the cleaner.
8.
DO NOT
run the vacuum cleaner over cord. The revolving
brush could damage the cord.
9. Use caution when vacuuming over area rug edges and
fringe.
Disposable Paper Filter Dust Bags
Disposable paper filter dust bags play a very important role in
the efficiency of your ORECK vacuum cleaner. The purpose of
the paper bag is to trap dirt, but at the same time it must be
porous enough to allow air to pass through. If the paper bag
becomes clogged, no air can pass through the cleaner and
cleaning cannot take place, regardless of the cleaner’s power.
Increase the CLEANING POWER of your cleaner by changing
the bag often.
To keep your cleaner operating at maximum efficiency, change
the dust bag frequently. DO NOT FILL ABOVE THE LINE
INDICATED ON THE DUST BAG.
Be sure the disposable paper filter dust bag is installed properly.
All paper dust bags are not the same. Your ORECK
disposable dust bags have been designed to be used with
the ORECK cleaner. Using bags other than genuine ORECK
disposable bags will affect the cleaning ability of your
cleaner and could cause damage to it.
The Belt
The belt on your vacuum cleaner controls the speed of the
revolving brush and is very important for the effective operation
of the cleaner. If the belt becomes stretched or cut, it will cause
the revolving brush to stop completely or slow down. See
instructions in the manual for replacing belt.
An extra belt is stored in the baseplate of your cleaner.
When buying replacement belts, use ONLY ORECK genuine
belts. Belts other than Oreck belts will not operate the
revolving brush correctly and may create undue stress
which will cause damage to the motor and brush bearings.
Using belts other than ORECK belts will void the warranty.
5