Panasonic 60LCX64 Mmd Digital Tuner - Page 37

Basic Operation Device display operation Changing the input signal The input source for picture signals can be changed by pressing TV/VIDEO, SD on the Remote Control or TV/VIDEO on the unit. Remote Control The input mode changes each time this button is pressed. TV HDMI*1 *1 If SKIP is set as the Input Label setting of Channel Caption, the mode will not be changed. (See page 71.) RGB 2*1 RGB 1*1 Video 1*1 Comp 3*1 Video 2*1 Comp 2*1 Card input mode (Photo Viewer) is selected. Video 3*1 Comp 1*1 Or Device display Unit *1 Changing input is only possible if Cable/ Antenna is set as the Input Set setting. *2 If SKIP is set as the Input Label setting of Channel Caption, the mode will not be changed. (See page 71.) TV (Antenna A) TV (Antenna B*1) Video 1*2 Video 2*2 Video 3*2 HDMI*2 RGB 2*2 RGB 1*2 Comp 3*2 Comp 2*2 Comp 1*2 Video 1 Video 2 Video 3 Comp 1 Comp 2 Comp 3 RGB 1 RGB 2 HDMI Signal of source connected to INPUT 1 is displayed. Signal of source connected to INPUT 2 is displayed. Signal of source connected to INPUT 3 is displayed. Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed. Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed. Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed. Signal of source connected to RGB IN 1 is displayed. Signal of source connected to RGB IN 2 is displayed. Signal of source connected to HDMI IN is displayed. Photo (Photo Viewer) Signal of source connected to CARD SLOT is displayed. 37