Panasonic AG-HCK10G POVCAM Cable Specs - Page 2
<<Specification>> - ag hmr10
View all Panasonic AG-HCK10G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
1. Connectors HR25-9TP-20P (72) Hirose Co. 2009.12.25 Ver.1 2. Wiring (1) LVDS differential shield lines : 4 pairs Impedance : differential 100 ohm Wire type : #30 or bigger twisted shield wire (2) Command differential lines : 2 pairs Wire type : #30 or bigger twisted (3) Power lines : 2 pcs Wire type : #24 or bigger (for 3m length), #22 or bigger (for 20m length) Total impedance has to be less than 1 ohm. (4) Signal lines : 2 pcs Wire type : #30 or bigger (5) Meshed shield All those lines have to be covered with meshed shield. The shield has to be connected to the body of the connectors. 3. Note The signal [SEL_LENGTH] is connected to GND on AG-HCK10 (camera). In case the AG-HMR10 (Recorder) would detect the GND status on [SEL_LENGTH] signal (that means the [SEL_LENGTH] line is closed), the parameters inside AG-HMR10 will be set for using longer cables. (10m - 20m, or 33' - 67') In case of using shorter cables (3m - 10m, or 10' - 33'), the [SEL_LENGTH] terminal has to be open. 2