Panasonic AG-HMX100 Mixers Switchers Catalogue - Page 19

 AW-HS50 AG-HMX100 (As of April, 2012) DC 12 V ±10 % (AC adapter provided), 2.0 A 0 °C to 40°C (32 °F to 104 °F) 10 % to 90 % (no condensation) 210 mm x 67 mm x 177 mm (8-1/4 inches x 2-5/8 inches x 6-15/16 inches) (excluding protrusions) AC 100 V to 240 V, 50 Hz/60 Hz, 60 W 5 °C to 40 °C (41 °F to 104 °F) 10 % to 80 % (no condensation) 424 mm x 197 mm x 400 mm (16-3/4 inches x 7-3/4 inches x 15-3/4 inches) (excluding protrusions) Approx. 1.4 kg (3.1 lb) (without options) Approx. 7.9 kg (17.4 lbs) (without options) HD: SD: 1080/59.94i, 1080/50i, 1080/24PsF, 1080/23.98PsF, 720/59.94p, 720/50p 480/59.94i, 576/50i HD: SD: 1080/23.98PsF (for 3D only), 1080/59.94i, 1080/50i, 720/59.94p, 720/50p 480/59.94i, 576/50i *Mixed operation of different video formats is not possible. Y:CB:CR 4:2:2, 10 bit (8 bit for FMEM)/ RGB 4:4:4, 8 bit Y:PB:PR:Key 4:2:2:4, 12 bit (Internal process) 1ME 1ME SDI: DVI-D: 4 lines, BNC x 4 HD (SMPTE292M)/SD (SMPTE259M) standard 0.8 V [p-p] ±10 % (75 Ω) 1 signal line, DVI-D x 1 (Analog input signals are not supported) VIDEO: SDI: HDMI: DVI-I: 2 lines, BNC x 2, Analog Composite, 1.0 V[p-p] (75 Ω) 4 lines, BNC x 4 HD (SMPTE292M/296M/299M) /SD (SMPTE259M-C/272M-A, ITU-R. BT.656-4) standard 2 signal lines, HDMI x 2 (Type A connector), incompatible with HDCP Link and VIERA Link TMDS single link (incompatible with HDCP), compatible with digital/analog RGB SDI: DVI-D: 2 lines, BNC x 3 (2 output distribution for OUT1) HD (SMPTE292M)/SD (SMPTE259M) standard 0.8 V [p-p] ±10 % (75 Ω) 1 signal line, DVI-D x 1 (Analog output signals are not supported.) SDI: DVI-D: 4 lines, BNC x 4 (PGM/PVW/AUX/MULTIVIEW x each) HD (SMPTE292M/296M/299M) /SD (SMPTE259M-C/272M-A, ITU-R. BT.656-4) standard 2 lines, DVI-D x 2 (PGM/MULTIVIEW x each) TMDS single link (not compatible with HDCP) - - - - - D-sub 15 pin x 1, GPI INPUT x 5 channels (photocoupler sensing), GPI OUTPUT x 7 channels (open collector output) RJ45, 10 BASE-T/100 BASE-TX - External reference (G/L) input: BNC x 2 (with loop-through), 1.0 V [p-p] (75 Ω), Analog composite (NTSC/PAL) Advanced reference (ADV-REF) output: BNC x 1, 75 Ω, Analog composite Sync: 0.286 V [p-p] (NTSC)/0.3 V [p-p] (PAL) Burst: 0.286 V [p-p] (NTSC)/0.3 V [p-p] (PAL) AUDIO input: XLR: 4 lines (L and R), +4/0/-3 dBm switchable, balanced, 600 Ω SDI (embedded audio): 4 lines, HD (SMPTE292M/296M/299M)/SD (SMPTE259M-C/272M-A, ITU-R BT.656-4) standard HDMI (embedded audio): 2 lines, Type A connector (not compatible with HDCP) AUX input: Pin jack: 1 line (L and R),-10 dBV, High impedance, unbalanced MIC input: M6 x 1 line, -60 dBV, 2 kΩ, monaural, unbalanced AUDIO output: PGM: XLR: 1 line (L and R), +4/0/-3 dBm switchable, Low impedance, balanced Pin jack: 1 line (L and R), -10 dBV, Low impedance, unbalanced PGM/PVW/AUX OUT: SDI (Embedded Audio) x 1, HD (SMPTE292M/296M/299M)/SD (SMPTE259M-C/272M-A, ITU-R BT.656-4) standard PHONES output: M6 x 1, 8 Ω, stereo, unbalanced, -∞ dBu to -20 dBu - - D-sub 9 pin x 1, RS-232C TALLY output: D-sub 9 pin x 1, 8 Cross point, Open-collector, Maximum current: Less than 50 mA, Maximum Voltage: 35 VDC GPI: BNC x 1, Make-Contact - - CD-ROM (Operating instructions / Image transmission software), AC adapter CD-ROM (Operating instructions), Power code (3 core cable) Wipe x 13 Wipe (BASIC1+2) x 37, Wipe (+MULTI) x 16, Wipe (BLIND) x 23, Wipe (MATRIX) x 7, Squeeze (COMP+SINGLE) x 13, 2ch Squeeze (COMP+BOTH) x 8, Slide x 8 Cut, Mix, Wipe Cut, Mix, Wipe (including DVE) - Image effect: PGM/A, PST/B BUS Effect: Mosaic, Defocus, Mono, Time effects, Decay, Paint, Nega, Mirror 1 1 Linear key, Luminance key, Chroma key*8 Linear key, Luminance key, Chroma key, Full key Mix Cut, Mix, Wipe (including DVE) - Wipe x 6 - 1 - Luminance key - Mix 1 1 Mix Mix AUX BUS1 - SDI-IN 1 to 4, DVI-IN (always-on) SDI-IN 1 to 4, DVI-I IN, HDMI 1 to 2/Composite video 1 to 2 SDI-IN1 to 4, DVI-IN SDI-IN 1 to 4, DVI-I IN, HDMI 1 to 2/Composite video 1 to 2 SDI-IN3, 4 - - - SDI-IN 1 to 4 Every A/B bus 1 system*10, Labels, Tally indication, Split-screen (8 Patterns: 4, 5a/5b, 6a/6b, 9 and 10a/10b sections) 1 system Labels, Tally indication, Split-screen (the screen split into 10a only) OSD [Single Screen Display: SDI-OUT 2,DVI-OUT (unshown on SDI-OUT 1)], Chroma key sample marker, Audio Level Meter: SDI embedded audio (group1/ 1 ch, 2 ch) OSD (several MULTI outputs), WFM, Audio level meter, Embedded audio(SDI, HDMI) 2 channels *11 (The data for the images stored in the frame memories can be retained even when the power is turned off by saving it in the flash memory area which is incorporated inside the unit.) 1 systems: still images and movie clips - - PinP Preset, Effect dissolve function Event memory (100 patterns), Key learning (20 patterns) *7: May store and recall up to 10 presets (per camera) with current Panasonic pan-tilt systems. *8: May also be used for DSK applications by changing the key layer. *9: Plans call for supporting this function in the future. *10: OSD, MV frames, Labels, Tally indications, Audio Level Meters, and Camera setting information are not shown on SDI-OUT 1. *11: OSD, MV frames, Labels, Tally indications, Audio Level Meters, and Camera setting information for MultiViewer Display are not stored in the Frame Memory. 18