Panasonic AWHE100N AWHE100N User Guide - Page 39

Genlock adjustment 3 Press the [] or [] button to make "G/L, Setup Set" blink. 4 Press the [] or [] button. The "G/L, Setup Set" sub-menu is displayed.  G/L, Setup Set  H Phase SC Coarse SC Fine Setup Level +1 180deg ±0 On Return 5 Press the [] or [] button to make the "SC Coarse" or "SC Fine" value blink. Use the "SC Coarse" item to perform coarse adjustments, and the "SC Fine" item to perform fine adjustments. 6 Press the [] or [] button to change the value, and adjust so that the color phase is aligned. 7 Press the [MENU] button for two seconds. The menu display is exited. 8 Press the [MODE] button. The mode is switched to the camera picture display. When doing the adjustment using the controller The same operations as in steps 2 to 7 of "When performing the operations using the accessory wireless remote control" can be performed following the operation procedure for "Basic menu operations" (pages 40 to 42). To switch between "BAR" (color bar display) and "CAM" (camera pictures), press the [MODE] or [BAR/CAM] button. When the AW-RP655 is connected: 1 Press the [MODE] button. The button's lamp lights, and the mode is switched to the color bar display. 2 Press the [MENU] button. 3 Turn the jog dial (main) to display "G/L SETTING" on the LCD panel. 4 Press the [OK] button, and display "H PHASE" on the LCD panel. 5 Turn the jog dial (main) to display "SC PHASE" on the LCD panel. 6 Turn the jog dial (L) or the jog dial (R) and adjust it to bring the horizontal phase into alignment. Use the jog dial (L) to adjust the phase coarsely and the jog dial (R) to adjust it finely. 7 Press the [MODE] button. The button's lamp goes off, and the display is switched to the camera picture. Note  When horizontal phase adjustment is moved, color phase is also moved. Adjust color phase whenever horizontal phase adjustment is moved. 39