Panasonic BL-WV10A BL-MS103A Owner's Manual (English) - Page 100

6 Setup Menu Note • Please be aware that when you make changes to values set during Quick Setup, you may lose access to the network. • If you make a mistake while changing these settings, use the FACTORY DEFAULT RESET button to restore the BL-WV10A's default settings (see page 131). Doing so, however, will reset all of your settings to their defaults, and sever the connections to the cameras. You will need to re-perform Quick Setup to register the cameras and set desired settings again. Camera Settings Change the camera network settings. Setting Starting Address Admin User Name Admin Password Description Set the IP address to be used when a camera is configured using Quick Setup. A maximum of 8 addresses will be created and used, starting sequentially from this entry. If you run Quick Setup after connecting a BB-HGW700A, the starting address will be displayed as [Auto] and cannot be set manually. Set the user name for local cameras for Quick Setup. This user name is used when connecting to local cameras. Set the password for local cameras for Quick Setup. This password is used when connecting to local cameras. Note • The administrator name and password must be between 6 and 15 alphanumeric characters in length. The following characters cannot be used: " < > : &. • When you re-register cameras using Quick Setup after changing the administrator name and password, the user name and password for the camera 100