Panasonic DMREH60 DMREH60 User Guide - Page 57
Channel/clock Settings When Tv Guide On Screen System Is Not Used
View all Panasonic DMREH60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Channel/Clock settings when TV Guide On ScreenTM system is not used Refer to the control reference on page 54. Preparation: If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below. When the unit is on and stopped 1 Press and hold [X CH] and [W CH] on the main unit for about five seconds. The unit turns off. 2 Press [Í DVD POWER] to turn the unit on. 3 Complete the TV Guide On ScreenTM system setup (until [ENTER] is pressed after the "Watch TV" message screen is displayed). X CH W HDD DVD SD CH OPEN/CLOSE DRIVE SELECT REC /x1.3 S VIDEO VIDEO L/MONO-AUDIO-R DV IN IN2 [Note] You can set scheduled recording only manually after you set the unit with "Set Channels Automatically". Auto channel/clock settings 1 Press [SETUP]. 2 Press [3, 4] to select "Channel" and press [1]. 3 Press [3, 4] to select "Set Channels Automatically" and press [ENTER]. 4 Press [2, 1] to select "Yes" and press [ENTER]. 5 Press [ENTER]. Auto Channel Setting starts. This takes a few minutes. The unit then proceeds with Auto Clock Setting. The time is displayed when finished. SETUP Set Clock Automatically Channel Auto Clock Setting is complete. Setup Disc Video Audio 4/4/2005 12:15 AM DST On Time Zone..... CST ≥DST, Daylight Saving Time, shows the summertime setting. ≥TIME ZONE shows the time difference from Greenwich Mean Time (GMT). EST (Eastern Standard Time) l GMT j5 CST (Central Standard Time) l GMT j6 MST (Mountain Standard Time) l GMT j7 PST (Pacific Standard Time) l GMT j8 AST (Alaska Standard Time) l GMT j9 HST (Hawaii Standard Time) l GMT j10 For other areas: xx hr ≥If the Auto Clock Setting does not start automatically, select "Clock Settings" from the "Setup" tab and then select "Set Clock Automatically". ≥If the time was not set correctly, use manual clock setting (➡ 17) or adjust time zone. 6 Press [ENTER]. ≥The unit configures channels according to the Signal Source (RF IN) settings as follows. Signal Source (RF IN) Band Channel Antenna VHF UHF 2-13 14-69 VHF 2-13 CATV LOW BAND 95-99 CATV MID/SUPER BAND 14-36 CableTV CATV HYPER BAND 37-65 ULTRA BAND 66-94 100-125 SPECIAL CATV CHANNEL 1 Adjust Time Zone Adjust the time zone (j1 or i1) if it was not set correctly with auto clock setting. You cannot change this setting if you set the clock manually. 1 Press [SETUP]. 2 Press [3, 4] to select "Setup" and press [1]. 3 Press [3, 4] to select "Clock Settings" and press [ENTER]. 4 Press [3, 4] to select "Adjust Time Zone" and press [ENTER]. SETUP Adjust Time Zone j1 Channel 0 Setup i1 Disc Video 5 Press [3, 4] to select "s1" or "r1" and press [ENTER]. To return to the previous screen Press [RETURN]. To exit the screen Press [SETUP]. To cancel partway while Auto Channel/Clock Setting is taking place Press [RETURN]. Convenient functions To set so the television program list is not displayed automatically when you turn the unit on ➡ 29, "Review Options" menu-Selecting the TV Guide On ScreenTM system start up pattern RQT8307 57