Panasonic EW3109W Operating Instructions - Page 18
Storing, Measurement, Values
View all Panasonic EW3109W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Storing Measurement Values This product can store 90 measurement values. Panmonle After measurement, press the Memory/Recall button while the M mark is blinking. SYSTOLIC Ha DIASTOLIC mmHg 138 82 (1%2 ONOff astrt ITT' Panmen Storing is completed. • Up to 90 measurement values can be stored. When the memory is full and additional values are stored, the oldest value in memory will be deleted and the new value will be stored. • If measurements could not be taken properly (the E mark is shown instead of the blood pressure value), measurement values cannot be stored. * However, even if the E mark is shown for the blood pressure value, the pulse value will still be stored. SYSTOLIC ro DIASTOLIC m Hg 82 Number of stored data 52 PUlee/rnIn. o WR astrt To erase all measured values stored in memory: 1. Press the Memory/Recall button. The stored measurement values will be displayed. 2. Press the same Memory/Recall button again, and hold it pressed until the measurement values disappear (approximately 3 seconds or more). * It is not possible to erase single measurement values. 3. The M mark and 00 will be shown when all data is deleted. TartOn/Off Tr 17 To switch off the blood pressure monitor, press the On/Off Start button. • If you forget to switch it off, the blood pressure monitor will switch off automatically after approximately 5 minutes.