Panasonic EW3152A Instruction Manual - Page 26

TROUBLESHOOTING Display Status before error Remeasure mark E is displayed. Pressurization to more than 280mmHg was performed. Pressure deceased suddenly and the remeasure mark E appeared. E The heart mark r blinked only a few times or not at all. No pressurization Cause and solution Weremeasurementstaken accordingto theproperprocedure and in the correctposture? See p.13 and14. Besureyouramis properly insertedit themainunit. See p. 13. If problem continues Symptom Systolic or diastolic blood pressure value is high or low. Value is different from that measured by the doctor. Measurement values are different vrith each measurement No display appears even when the OnlOff Start button is pressed. WhentheOnlOffStartMon is pressed, the display disappears during pressurization(O0 mark apears). During pressuration, the sound or pressurization ma changes. Pressure cuff comes off. Possible cause . You moved or talked during measurements. . Your arm was not inserted properly into the main unit See p.13 and 14. . Blood pressure varies in response to minute changes in your mental state, such as your reaction to a dolor's presence. . Rolm for 4 to 5 minutes and take another measurement. See p.14 and 17. Bataries are installed with the polarities wrong. See p.11. . Blades are otausted. See p. 11. . Since measurements are taken during pressurization, operating sound may be heard and pressurization rate may change during pressurization. This is normal and is not a malfunction. . Press the ring portion on the outside of the pressure cuff into the main body. Seep. 18. Instrument is broken. Take it to the store where it was purchased for testing and repairs. 26