Panasonic FV08VFL2 Installation Instructions - Page 7

INSTALLATION I (JOIST MOUNTING-I) CONTINUED 3. Install the suspension bracket and the flange of fan body to joists by using long screws (ST4.2X20). ( If spacing A between joists is 10 1/4-12 inches, install the flange of Joist fan body according to Fig.3-2, others according to Fig.3-1 to install the product.) (CD Joist Fan body 4 Long screws (ST4.2X20) Fig.3-1 A=10 1/4-12 inches Joist 4. Install the suspension bracket to joists by using long screws (ST4.2X20) and secure it to the fan body by using screw II (ST4.2X12). (Fig.4) 5. Remove junction box cover and secure conduit or stress relief to junction box knock-out hole. (Fig.5) 6. Refer to wiring diagram below. Using wire nuts, connect house power wires to ventilating fan wires: black to black; white to white; green to green; Replace the junction box cover. ( Fig.5) Wiring diagram Current Fuse 3.15 A Bectronic Ballast uorescent mp Fart body Motor Red T Capacitor White White White Black [21 Black White White Black Black Black Green Green G Ben Lighting unit Neutral Live Neutral Live Earth ground Power Supply AC 120 V 60 Hz Earth ground Night Lamp Junction box Black -- Black White White Power Supply AC 120 V 60 Hz CAUTION: Mount junction box cover carefully so that lead wires are not pinched. 7. Install a circular duct (using 4 inches duct or 3 inches duct) and secure it with duct tape or clamps. 7 Joist 0 Fan body 2 Long screws (ST4.2X20) Fig.3-2 Joist Joist 2 Long screws (ST4.2X20) 7 O 3' 0 Screw 11 (ST4.2X12) Fig-4 Circular duct Conduit Junction box cover Joist 0 tl Duct tape or clamps Joist Conduit Junction box Wire nut Lead wires Green wires Fig. 5