Panasonic KXTG2214P KXTG2214F User Guide - Page 40

Troubleshooting Problem Cause & Remedy The unit does not work. • Check the settings (p. 8-9). • Check whether the dialing mode setting is correct (p. 12). • Charge the battery fully (p. 8). • Clean the charge contacts and charge again (p. 9). • Install the battery properly (p. 8). • Place the handset on the base unit and unplug the AC adaptor to reset it. Plug in, and try again. • Re-install the battery (p. 8) and charge it fully. "No link to base. Place on cradle and try again." is displayed and an alarm tone sounds. • You are too far from the base unit. Walk closer and try again. • Place the handset on the base unit and try again. • Plug in the AC adaptor. • Raise the base unit antenna. Static, sound cuts in/out, fades. Interference from other electrical units. • Move the handset and the base unit away from other electrical appliances (p. 3). • Walk closer to the base unit. • Raise the base unit antenna. • Select a clearer channel (p. 18). The handset does not ring. • The ringer volume is set to OFF. Set to HIGH, MEDIUM or LOW (p. 15). The handset display is blank. • Charge the battery fully (p. 8). You cannot program function items. • Programming is not possible while the unit is being used. • Do not pause for over 60 seconds while programming. • Walk closer to the base unit. While programming or searching, the unit starts to ring and stops the program/search. • A call is coming in. To answer the call, press [ ] or [ ]. Start again from the beginning after hanging up. 40