Panasonic KXTG2553S 2.4 Ghz Cordless Pho - Page 51
Before Requesting Help
View all Panasonic KXTG2553S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Before Requesting Help Problem "No link to base. Place on cradle and try again." is displayed and an alarm tone sounds. The unit does not work. Static, sound cuts in/out, fades. Interference from other electrical units. The handset does not ring. The handset display is blank. The handset display is still blank after pressing Ö, Ñ, BACK Ü or FWD/EDIT á. Remedy •You are too far from the base unit. Move closer and try again. •Place the handset on the base unit and try again. •Plug in the AC adaptor. •Raise the base unit antennas. •Check the settings (p. 11-15). •Charge the battery fully (p. 12). •Clean the charge contacts and charge again (p. 13). •Install the battery properly (p. 49). •Place the handset on the base unit and unplug the AC adaptor to reset. Plug in, and try again. •Re-install the battery and place the handset on the base unit (p. 49). Try again. •Locate the handset and the base unit away from other electrical appliances (p. 3). •Move closer to the base unit. •Raise the base unit antennas. •Press (FUNCTION/EXIT/CH) to select a clearer channel. •The ringer volume is set to OFF. Set to HIGH or LOW (p. 18). •The handset is in the standby mode (p. 13). Press Ö, Ñ, BACK Ü or FWD/EDIT á to turn the display on. •Charge the battery fully (p. 12). Useful Information 51