Panasonic MCV5210 MCV5210 User Guide - Page 30
REPLACING BELT, Groove, End Cap
UPC - 037988720026
View all Panasonic MCV5210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Replacing Belt ➢ Replace belt whenever a burning rubber smell caused by excessive slippage occurs. Belt Cover Couvercle de la courroie Cubierta de la banda Agitator Holder Support de l'agitateur Soporte de l'agitador Lift Agitator Up Soulever l'agitateur Unidad del agitador Motor Shaft Arbre d'entraînement du moteur Eje del motor Install New Belt Poser la nouvelle courroie Instalación de la correa ➢ Remove lower plate. ➢ Lift rear belt cover and remove agitator holder. ➢ Remove agitator by carefully lifting out. ➢ Remove worn or broken belt. ➢ Clean agitator. ➢ Loop new belt (Panasonic Type UB8 only) around motor shaft and agitator pulley. Groove Ouverture Ranura End Cap Bouchon Tapa de extremo ➢ Reinstall agitator back into nozzle housing grooves. ➢ Close rear belt cover and reinstall agitator. ➢ After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely. ➢ Reinstall lower plate. (See Removing and Installing Lower Plate, page 28). - 30 -