Panasonic PTDW7000U Dlp Projector - English/ French - Page 98
Indication Of Monitor Lamp
View all Panasonic PTDW7000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Indication of monitor lamp Three monitor lamps are provided at the top of main unit front to inform the user of the lamp replacement time and unusual internal temperature. These lamps indicate the degree of abnormality by combination of blinking and/or lighting lamps. Turn off the power and take the proper measure according to the table below. TEMP LAMP1 LAMP2 POWER Lamp 2 monitor (LAMP2) Lamp 1 monitor (LAMP1) Temperature monitor (TEMP) Name of monitor lamp Temperature monitor TEMP Lamp monitor LAMP1 LAMP2 Lamp indication Information Checkpoint Remedial measure Lighting in red (lamp unit ON) Blinking in red (2 times) Warm-up status High temperature inside. (WARNING) High temperature inside (Standby condition) • Did you turn on the power when the ambient temperature was low (approx. 0 °C)? • Wait about five minutes in the current status. • Install the unit in a location having an ambient temperature from 0 to 40 °C. • Remove the object that is • Check if the ventilation port is blocked. • Is the room air temperature too high? • Check the air filter for clogging. blocking the ventilation port. • Move the projector to a temperature of 0 to 40 ˚C and the humidity of 20 to 80% (no condensation). • Turn off the MAIN POWER switch using the procedure on page 40 and clean the air filter (refer to page 99). Blinking in red (3 times) Lighting in red Blinking in red (3 times) Cooling fan has been stopped. Indicates the time for replacing the lamp unit. Error is detected in the lamp circuit. • Turn off the main power supply (MAIN POWER) switch in the procedure shown on page 40 and consult the distributor. • Did you notice a "REPLACE THE LAMP" message on the screen when turning on the projector power supply. • This lamp monitor lights up when the lamp unit used hours have reached 1 300 hours (3 800 hours when Long Life Lamp Units are used). Request the dealer to replace the lamp unit. • Did you turn the power back on immediately after turning it off? • Wait until the lamp has cooled off, and then turn on the power. • Some error has arisen in the lamp • Turn off the MAIN POWER circuit. switch using the procedure on • Check for fluctuation page 40 and consult the (or drop) in the source dealer. voltage. 98 Attention • Be sure to observe the procedure (How to turn "ON" and "OFF" the power supply) on page 39-40 when performing power supply operation to take a measure to the indication of temperature monitor (TEMP) lamp and lamp monitor (LAMP) lamp.