Panasonic SAAK633 Mini Hes W/cd Player - Page 15

Specifications AMPLIFIER SECTION AK630 RMS output power THD 10%, both channels driven 1 kHz (Low channel) 75 W per channel (5 Ω) 10 kHz (High channel) 70 W per channel (5 Ω) 80 Hz (Subwoofer channel) 160 W (8 Ω) Total power output 450 W FTC output power THD 10%, both channels driven 100 Hz-3 kHz (Low channel) 59 W per channel (5 Ω) 3 kHz-10 kHz (High channel) 57 W per channel (5 Ω) 50 Hz-100 Hz (Subwoofer channel) 130 W (8 Ω) Total FTC power 362 W AMPLIFIER SECTION AK633 RMS output power THD 10%, both channels driven 1 kHz (Low channel) 70 W per channel (5 Ω) 10 kHz (High channel) 65 W per channel (5 Ω) 80 Hz (Subwoofer channel) 160 W (8 Ω) Total power output 430 W FTC output power THD 10%, both channels driven 100 Hz-3 kHz (Low channel) 55 W per channel (5 Ω) 3 kHz-10 kHz (High channel) 53 W per channel (5 Ω) 50 Hz-100 Hz (Subwoofer channel) 130 W (8 Ω) Total FTC power 346 W FM/AM TUNER, TERMINALS SECTION Preset station FM 15 stations AM 15 stations Frequency Modulation (FM) Frequency range 87.9-107.9 MHz (200 kHz steps) 87.5-108.0 MHz (100 kHz steps) Sensitivity 2.5 ØV (IHF) S/N 26 dB 2.2 ØV Antenna terminal(s) 75 Ω (unbalanced) Amplitude Modulation (AM) Frequency range 520-1710 kHz (10 kHz steps) Sensitivity S/N 20 dB (at 1000 kHz) 560 ØV/m Audio performance (Amplifier) Input sensitivity/Input impedance Aux 250 mV, 14.7 kΩ Phone jack Terminal Stereo, 3.5 mm (1/8˝) jack CASSETTE DECK SECTION Track system 4 track, 2 channel Heads Record/playback Solid permalloy head Erasure Double gap ferrite head Motor DC servo motor Recording system AC bias 100 kHz Erasing system AC erase 100 kHz Tape speed 4.8 cm/s (17/8 ips) Overall frequency response (+3 dB, -6 dB at DECK OUT) NORMAL 35 Hz-14 kHz S/N ratio 50 dB (A weighted) Wow and flutter 0.18% (WRMS) Fast forward and rewind time Approx. 120 seconds with C-60 cassette tape DISC SECTION Discs played [8 cm (3˝) or 12 cm (5˝)] (1) CD-Audio (CD-DA) (2) CD-R/RW (CD-DA, MP3 formatted disc) (3) MP3 Bit rate MP3 32 kbps-320 kbps Sampling frequency MP3 32 kHz, 44.1 kHz, 48 kHz CD 44.1 kHz Decoding 16 bit linear Digital filter 8 fs D/A converter MASH (1 bit DAC) Pickup Wavelength 780 nm Beam Source Semiconductor laser Audio output (Disc) Number of channels 2 (Stereo) (FL, FR) SPEAKER SECTION Front speakers SB-AK630 Type 3 way, 3 speaker system (Bass reflex) Impedance HIGH 5 Ω LOW 5 Ω Speaker(s) Woofer Tweeter 16 cm (61/2˝) cone type 6 cm (23/8˝) cone type Super tweeter Piezo type Input power (IEC) HIGH 70 W (Max) LOW 75 W (Max) Output sound pressure level 83 dB/W (1.0 m) Cross over frequency 2.6 kHz, 10 kHz Frequency range 37 Hz-23 kHz (-16 dB) 44 Hz-22 kHz (-10 dB) Dimensions (WxHxD) 240 x 330 x 230 mm (97/16˝ x 13˝ x 91/16˝) Mass 3.2 kg (7.1 lb.) Subwoofer SB-WAK630 Type 1 way, 1 speaker system (Bass reflex) Impedance 8 Ω Speaker(s) Subwoofer 16 cm (61/2˝) cone type Input power (IEC) 160 W (Max) Output sound pressure level 80 dB/W (1.0 m) Frequency range 40 Hz-220 Hz (-16 dB) 45 Hz-180 Hz (-10 dB) Dimensions (WxHxD) 240 x 330 x 267 mm (97/16˝ x 13˝ x 101/2˝) Mass 3.4 kg (7.5 lb.) GENERAL Power supply Power consumption AC 120 V, 60 Hz 255 W Dimensions (WxHxD) 250 x 330 x 341 mm (927/32˝ x 13˝ x 137/16˝) Mass 7.1 kg (15.7 lb.) Operating temperature range +5 to +35 °C (+41 to +95 °F) Operating humidity range 5 to 90 % RH (no condensation) Power consumption in standby mode: 0.38 W Note: 1. Specifications are subject to change without notice. Mass and dimensions are approximate. 2. Total harmonic distortion is measured by the digital spectrum analyzer. 3. The labels "HIGH" and "LOW" on the rear of the speakers refer to High frequency and Low frequency. Maintenance If the surfaces are dirty T•• oNBceelfveoearrenutushseiisnagulcnaoihtc,ohwl,eipmpaeicinawtlltiyhthitnraneeasrteoodfrt,cbdleorntyhz,icnlreoetathod. clean this unit. the instructions that came with the cloth carefully. For a cleaner, crisper sound Clean the heads regularly to assure good quality playback and recording. Use a cleaning tape (not included). Product Service 1. Damage requiring service -The unit should be serviced by qualified service personnel if: (a)The AC power supply cord or AC adaptor has been damaged; or (b)Objects or liquids have gotten into the unit; or (c)The unit has been exposed to rain; or (d)The unit does not operate normally or exhibits a marked change in performance; or (e)The unit has been dropped or the cabinet damaged. 2. Servicing -Do not attempt to service the unit beyond that described in these operating instructions. Refer all other servicing to authorized servicing personnel. 3. Replacement parts -When parts need replacing ensure the servicer uses parts specified by the manufacturer or parts that have the same characteristics as the original parts. Unauthorized substitutes may result in fire, electric shock, or other hazards. 4. Safety check -After repairs or service, ask the servicer to perform safety checks to confirm that the unit is in proper working condition. Product information For product information or assistance with product operation: In the U.S.A., refer to "Customer Services Directory" on the back cover. In Canada, contact the Panasonic Canada Inc. Customer Care Centre at 905-624-5505, or visit the website (www.panasonic.ca), or an authorized Servicentre closest to you. 15 RQT7834