Panasonic SAHT720 SAHT692 User Guide - Page 23
Manual tuning, Optional antenna connections, Press [INPUT SELECTOR] to select FM
View all Panasonic SAHT720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
The radio Manual tuning Main unit only 1 Press [INPUT SELECTOR] to select "FM" or "AM". 2 Press [TUNE MODE] to select "MANUAL". 3 Press [X TUNING] or [TUNING W] to select the frequency. Press and hold [X TUNING] or [TUNING W] until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found. Presetting the channel one by one 1 Tune to the station (‹ above). 2 Press [ENTER]. 3 While "PGM" is flashing on the display Press the numbered buttons to select a channel. Alternatively, press [X CH] or [W CH], then press [ENTER]. RDS PS PTY DISC SLEEP RND D.MIX SEQ PROG. PGM TTL GRP S.SR TRCK CHAP P D The station occupying a channel is erased if another station is preset to that channel. ∫ Allocation settings Main unit only Each country allocates broadcast bands according to their particular system. [For\U.S.A.,\Canada,\and\units\with\PX\printed\on\the\outer\packaging] You can change the FM step. The step is factory-set to 0.2 MHz, but you can change it to receive broadcasts allocated in 0.1-MHz steps. [For\Latin\America] You can change the AM step. The step is factory-set to 9 kHz, but you can change it to receive broadcasts allocated 10-kHz steps. 1 Press [INPUT SELECTOR] to select "FM" (for either band). 2 Press and hold [INPUT SELECTOR]. After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed. To return to the original step, repeat the above steps. [Note] Any FM/AM frequencies preset in channels will be changed by this procedure. Preset them again. Optional antenna connections Use outdoor antennas if radio reception is poor. ≥Disconnect the antenna when the unit is not in use. ≥Do not use the outdoor antenna during an electrical storm. FM outdoor antenna (Using a television antenna) ≥Disconnect the FM indoor antenna. ≥The antenna should be installed by a competent technician. Rework your outdoor antenna's 75 ≠ coaxial cable as follows (Except \Latin[America]). Leave the loop antenna connected. AM outdoor antenna (Using a vinyl wire) Run a piece of vinyl wire horizontally across a window or other convenient location. 5-12 m (16 - 39 feet) 75 ≠ coaxial cable (not included) Antenna plug (included \U.S.A.\and\Canada]) AM ANT L A LOOP EXT R (Except \Latin[America]) 1 Remove a piece of the outer vinyl insulator. 10 mm (13/32z) 2 Carefully pull the tabs apart to remove the cover. 2 3 Install the coaxial cable. Clamp the cable conductor, and wind it on so that it does not contact anything else. 4 Attach the cover. 10 mm (13/32z) Peel back 1 1 7 mm (9/32z) Clamp with pliers RQT7433 23