Panasonic TH-47LFX6 Operating Instructions - Page 4

Installation position, Installation conditions, To install on a wall etc.

Page 4 highlights

Precautions for Installation Protective coating Cabinet aluminum parts and rear face are protected from corrosion with coating. Be careful not to damage the surface. In case the surface is damaged, corrosion may occur from there. Installation position • When direct sunlight is on the screen, black shadow may appear. This will disappear when the temperature drops. • To install the product long term in a special environment such as near a swimming pool, hot spring, or ocean, or in a factory uses chemicals or gases, please consult your local Panasonic dealer beforehand. • The product is equipped with cooling fans and air ¿lters that need to be cleaned or replaced if covered with dust. Removing or installing air ¿lters requires space around the Display. With this in mind, provide adequate space when installing the Display. [Height 7.874"/200 mm or greater, Width 7.874"/200 mm or greater, Depth 7.874"/200 mm or greater] d d d d d d d:7.874"/200 mm or greater d d d d Installation conditions To use the product in an environment where outdoor air temperature is lower than 32 °F (0 °C), make sure to set the "Outdoor mode" to "On". The inside temperature is kept constant and the startup can be performed smoothly. (see page 17, 33) Do not exhibit or use this product in a condition where water splashes on to it continuously for long time. Always use the product at an ambient temperature in the range of 32 °F - 104 °F / 0 °C - 40 °C (during Outdoor mode: -4 °F - 104 °F / -20 °C - 40 °C). Set Outdoor mode to "On" if the Display is installed where direct sunlight is on the screen. To install on a wall etc. • Consult your dealer about ¿ttings etc. beforehand. • Choose a permanent position where the total weight of the product and ¿ttings can be hold permanently. If the strength of the position is not suf¿cient, a serious accident such as fall may be caused. • Do not install the product where a person can be hang or lean on, or a passer may collide into. Accident may be caused. • Take measures for tipping over and fall with an assumption of a ¿tting or installation location failure. • Installation strength may be degraded due to aging depends on the environment. Ask a installation professional to inspect or repair regularly. • When an abnormality or fault such as loose screw is detected, ask an installation professional or your dealer immediately for repair. • Panasonic will not be responsible for any damages from an accident such as defect of installation, improper use, modi¿cation, or natural disaster. iv

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71

iv
Protective coating
Cabinet aluminum parts and rear face are protected from corrosion with coating. Be careful not to damage
the surface. In case the surface is damaged, corrosion may occur from there.
Installation position
When direct sunlight is on the screen, black shadow may appear. This will disappear when the temperature
drops.
• To install the product long term in a special environment such as near a swimming pool, hot spring, or ocean, or in
a factory uses chemicals or gases, please consult your local Panasonic dealer beforehand.
• The product is equipped with cooling fans and air
¿
lters that need to be cleaned or replaced if covered with dust. Removing
or installing air
¿
lters requires space around the Display. With this in mind, provide adequate space when installing the Display.
[Height 7.874”/200 mm or greater, Width 7.874”/200 mm or greater, Depth 7.874”/200 mm or greater]
d
d
d
d
d
d
d
d
d
d
d:7.874”/200 mm or greater
Installation conditions
To use the product in an environment where outdoor air temperature is lower than 32 °F (0 °C), make sure to
set the “Outdoor mode” to “On”.
The inside temperature is kept constant and the startup can be performed
smoothly. (see page 17, 33)
Do not exhibit or use this product in a condition where water splashes on to it continuously for long time.
Always use the product at an ambient temperature in the range of 32 °F - 104 °F / 0 °C - 40 °C (during Outdoor
mode: -4 °F - 104 °F / -20 °C - 40 °C).
Set Outdoor mode to “On” if the Display is installed where direct sunlight is on the screen.
To install on a wall etc.
• Consult your dealer about
¿
ttings etc. beforehand.
• Choose a permanent position where the total weight of the product and
¿
ttings can be hold permanently. If the
strength of the position is not suf
¿
cient, a serious accident such as fall may be caused.
• Do not install the product where a person can be hang or lean on, or a passer may collide into. Accident may be
caused.
• Take measures for tipping over and fall with an assumption of a
¿
tting or installation location failure.
• Installation strength may be degraded due to aging depends on the environment. Ask a installation professional to
inspect or repair regularly.
• When an abnormality or fault such as loose screw is detected, ask an installation professional or your dealer
immediately for repair.
• Panasonic will not be responsible for any damages from an accident such as defect of installation, improper use,
modi
¿
cation, or natural disaster.
Precautions for Installation