Pfaff GrandQuilter Owner's Manual - Page 19

Operating your GrandQuilter™ Attaching the darning plate If you want to feed the fabric manually, for instance when stippling, you should use the darning plate (A) that has been provided with your GrandQuilter™. To attach the darning plate you should start by raising the presser foot lifter. Raise the needle to its highest position by pressing the Needle Up/ Down button twice. A Switch off the main switch and unplug the machine. Remove the two set screws and remove the standard needle plate. Put the darning plate in place and secure it with the two set screws. Placing a thread spool on the spool pin Place a spool of thread on the spool pin and put a large spool cap Àrmly against the spool. The thread should come off the spool as shown in the picture. Placing a thread cone on the spool pin If you are using a large thread cone, use a spool holder to hold the cone in place. Put the spool holder (B) on the spool pin, then place the thread cone on the spool holder. Note: If the spool is wobbly when sewing, cover the thread cone with the net that comes with the machine. B 17