Philips 40PFL4909 User manual - Page 41
Network selection, Wireless network setting, Manual network settings
View all Philips 40PFL4909 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Manual network settings 2 Use H I to select Manual network settings, then press OK. Network settings assistant Network selection Wireless Manual network settings Wireless network setting Auto Connection test IP configuration IP setting mode Setting status Proxy configuration Proxy setting Home network Reset network settings Network selection 3 Use H I to select Network selection, then press OK. 4 Use H I to select the desired setting, then press OK. Wired If you connect to an Ethernet cable, select Wired to connect to the Internet. Wireless If you have a router with WPS function, select Wireless to connect to the Internet. Wireless network setting This menu is displayed only when you set Wireless in Network selection. In order to use a wireless network, you must set up a connection to the AP (e.g. wireless router). 3 Use H I to select Wireless network setting, then press OK. Auto Search for wireless networks automatically and select the SSID from the list. 4 Use H I to select Auto, then press OK. 5 The list of wireless networks will be displayed. Use H I to select the appropriate the SSID, then press OK. Auto Router 1 Manually enter your SSID Router 2 Router 3 Router 4 Enter Key Select Enter Key Select 41 .English Easy Connect WPS code Manual Select this setting if your router has a Wi-Fi Protected Setup (WPS) button. Start scanning for wireless networks on the TV after pressing the WPS button on your router. If connection test fails, try Easy Connect again.*1 If it fails then refer to the router's manual for more details. Select this setting if your router has a WPS but does not have a WPS button. Enter the 8-digit WPS PIN code shown on your TV in the router settings menu via PC before Connect is selected. If your wireless network with authentication setting (WEP*2, WPA or WPA2), WEP*2 / WPA / WPA2 Key entry screen will appear. Enter the WEP*2 / WPA / WPA2 key of the selected wireless network using H I J K, then press OK. *1 WPS (Easy Connect) cannot be used when the security protocol is set to WEP. Change the Access Point's security mode from WEP to WPA or WPA2 (recommended). *2 WEP is not recommended to be used due to its Major security flaws. Change the Security protocol on the wireless router to WPA or WPA2 (recommended) mode. Confirmation message will appear. Select OK to complete the settings. Note(s) ● For a wireless network with authentication setting, key icon appears to the right hand of the SSID. ● Signal icon shows the strength of the signal. ● WEP*2 / WPA key appears as asterisks on the confirmation screen. ● The wireless LAN supports following specifications. - Wireless standards: IEEE 802.11 b/g/n - Frequency spectrum: 2.4GHz - Security protocol: WEP*2 / WPA / WPA2 ● If you select the SSID with , WEP*2 / WPA / WPA2 Key entry screen will appear. Enter the WEP*2 / WPA / WPA2 key of the selected wireless network using H I J K, then press OK. ● If you select the SSID has a WPS, the WPS setting screen will appear. Use H I J K to select a setting, then press OK. Continued on next page.