Philips 65PFL6902 User manual - Page 53

5 Useful tips 53 .English FAQ Question Answer • Check the antenna or cable connection to the main unit. • Check the batteries on the remote control. • Check if there is an obstacle between the infrared sensor window and the remote control. • Test the IR signal output use IR signal check. p. 56 My remote control does not If okay, then possible infrared sensor trouble. work. What should I do? • Aim the remote control directly at the infrared sensor window on the front of the unit. • Reduce the distance to the unit. • Re-insert or replace the AAA batteries with their polarities (+/-) as indicated on the remote control battery area. • When there is an infrared-equipped device such as PC near this unit, it may interrupt the remote control signal on this unit. Move the infrared-equipped device away from this unit, change the angle of the device's infrared sensor or turn off the infrared communication function. How come the initial setup appears every time I turn on • Make sure to complete the initial setup before the unit goes into standby mode. this unit? • Autoprogram must be completed when you set up the unit for the first time or move it to a location where previously unavailable channels are broadcast. • Make sure auto programming has been completed. p. 38 • The selected channel may not be broadcasting. Why can I not watch some RF signal TV programs? • When Auto programming is interrupted and not completed, some channels will not be received. Make sure to complete the Autoprogram. p. 38 • The selected channel cannot be viewed by the Child lock setting. p. 39 • The unit requires some kind of antenna input. An indoor antenna (Digital or VHF / UHF), an external antenna (Digital or VHF / UHF) or an RF coaxial cable from your wall cable or set-top box needs to be plugged into the unit. • Check if the correct input mode is selected by pressing SOURCE. p. 23 How come there is no image from the connected external • Check the antenna, cable or other input connection to the unit. devices? • When using the component video connection check that the green (Y), blue (Pb/Cb) and red (Pr/Cr) connectors are connected to their corresponding colored jacks on the unit. When I enter a channel • Many digital channels have alternate channel numbers. The unit changes the numbers automatically to the ones signifying number, why does it change the broadcasting station's channel number. These basic numbers used for the previous analog broadcasts. (e.g., input automatically? digital ch# 30 automatically changes to digital ch# 8.1) Why are captions not displayed entirely? Or why are captions delayed behind the dialog? • Closed captions that are delayed a few seconds behind the actual dialog are common for live broadcasts. Most captioning production companies can display a dialog to maximum of 220 words per minute. If a dialog exceeds that rate, selective editing is used to insure that the closed captions remain up-to date with the current TV screen dialog. How can I set the clock? • There is no clock function on this unit. My PIN code no longer • Although the default PIN code (0000) is supplied with the unit, the PIN code will be required once you set a PIN code in works, how can I change the Child lock. p. 39 child lock setting? When you forget your PIN code, enter 07 1 1 in Change PIN to reset the PIN code. p. 40 When I start up the TV or a net service, a message appears on the screen prompting for software • When you start up the TV or a net service after executing the software update, a message may appear on the screen prompting for software update again. In this case, please select Update to start USB update or network update. p. 46 update again. Continued on next page.