Philips HTS5100B User manual - Page 45

Introduction Connections Basic Setup Playback SETUPS Enable(Easy) HOME A "Play Disc Setup" A "Custom" A "Other" A "Network Connection" A "Enable (Easy)" Network settings are set to the following settings initially. (In most cases, you can connect to the Internet without making any changes to the default settings.) - IP Address Setting - DNS Setting - Proxy Setting - Connection Speed - BD-Live Setting Auto(DHCP) Auto(DHCP) Do Not Use Auto Allow If you want to set the network settings back to the default settings as above (except "BD-Live Setting"), follow the procedure below. 1) Follow steps 1) to 5) in "Connection Test" on page 44. 2) Use [K / L] to highlight "Enable(Easy)", then press [OK]. • The unit will start the connection test automatically and the test result will appear right after the test finishes. • After the connection test finishes, press [OK] to go to network status confirmation screen. 3) Press [OK] to activate the network settings and set the network connection automatically. Press [HOME ] to go back to the home menu. Note • The setting of "BD-Live Setting" will not be set back to the default, even if you follow the procedure. Enable(Custom) HOME A "Play Disc Setup" A "Custom" A "Other" A "Network Connection" A "Enable (Custom)" In following cases, select "Enable(Custom)" to set each setting as necessary. - When connection test failed with the setting of "Enable(Easy)". - When instructed by your Internet service provider to make specific settings in accordance with your network environment. • IP Address Setting / DNS Setting 1) Follow steps 1) to 5) in "Connection Test" on page 44. 2) Use [K / L] to highlight "Enable(Custom)", then press [OK]. 3) Use [K / L] to highlight "IP Address Setting", then press [OK]. 4) Use [K / L] to highlight the desired setting, then press [OK]. If you select "Manual", follow the following instruction to set the IP address and DNS. 4-a) IP address setting screen will appear. Enter IP address, subnet mask and default gateway with cursor buttons and number buttons. IP Address Setting IP Address Subnet Mask Default Gateway Clear OK • Enter the IP address number after checking the specifications of your router. • If the IP address number is unknown, check the IP address number of other devices. (e.g. PC connected via LAN cable) and assign a different number from those of other devices. After you enter all correctly, press [OK] to go to the DNS setting screen. 4-b) DNS setting screen will appear. Enter primary DNS and secondary DNS with cursor buttons and number buttons. DNS Setting Primary DNS Secondary DNS Clear OK • Enter the numbers instructed by your Internet provider. • If the number is unknown, check the number of other devices (e.g. PC connected via LAN cable) and assign the same number. 4-c) After you enter all correctly, press [OK]. • Confirmation message will appear. Select "Yes" to complete the settings. IP Address Subnet Mask Default Gateway Primary DNS Secondary DNS xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx Is Setting OK? Yes No 5) Press [BACK U] to go back to the previous screen, or press [HOME ] to go back to the home menu. "Auto(DHCP)" "Manual" : If your router has DHCP server function, select "Auto(DHCP)". : If your router does not have DHCP server function, select "Manual". Radio Tuning Function Setup Others EN 45